|
Photo Stability Chamber
Introduction
:
"Classic" make Photo Stability chamber
is design to suit standards for photogenic effect
along with temperature & Humidity for not less
than 1.2 million Lux hours and ultra violet source
of energy for not less than 200 watts hours/sq.
meter.
As per ICH & cGMP guidelines.
Range :
Temperature range : 10 C to 40 C
Temperature accuracy :
+/- 0.5 C
Temperature Uniformity : +/- 1
C
Humidity
range : 40
% r.h. to 80% r.h.
Humidity Accuracy : +/-
2% r.h.
Humidity Uniformity :
+/- 3% r.h.
Application
:
PHOTO STABILITY CHAMBER are used for studies
related to Photogenic effect on the samples exposed
to U.V. & day light illuminations. It is design
to create Nature Climatic conditions with the help
of Dry air, refrigeration & Humidity system
built-in. This Chambers are basically in application
with Pharmaceuticals, & also Electro-mechanical
R&D test to confirm the successful result of
the product under test.
Construction :
Photo
Stability Chambers are constructed with highly Insulated
"PUF" or Glass wool insulation. The body
is either galvanized or
stainless steel 304 quality, where as inner is 304
S.S. Door flush
type with full size glass door for viewing inside
objects with silicon gasket & locking arrangement.
Documentation :
Provided with DQ,IQ,OQ,PQ protocol & Validation
report.
Specification :
| Models |
CS-90a |
CS-90b |
CS-90c |
CS-90d |
| Chamber
Volume |
90.0
ltrs. |
170.0
ltrs. |
285.0
ltrs. |
340.0
ltrs. |
| Cubic
Feet |
3 |
6 |
10 |
12 |
| Internal
Size cms. |
40
X 40 X 57 |
50
X 40 X 85 |
57
X 57 X 88 |
60
X 60 X 95 |
| External
Size cms. |
53
X 68 X 135 |
63
X 68 X 163 |
70
X 85 X 166 |
73
X 88 X 173 |
| Shelves |
2 |
2 |
3 |
3 |
| Range |
+ 10 C upto
+ 40 C
|
| Controller
Accuracy |
+/-0.1 C of
set Value for Temp / + /- 2 % (Humidity)
|
| Uniformity |
+/- 0.5
C for Temp. +/- 3 % for Humidity
|
| Photogenic
effect |
Ultra
Violet wavelength 365nm. (measured in hours/square
meter)
Florescent light 4 nos. of >200 watts (measured
in Lux)
|
| Heat
up Time |
30 min. upto
40 C without load.
|
| Cool
Down time |
15 min.
upto + 10 C without load
|
| Cooler |
Plate
Fin Cooler
|
| Compressor |
Hermetically
Sealed Brand New Kirloskar Compressor
|
| Controller |
Microprocessor
based programmable P.I.D controller.
|
| Sensor |
Pt-100
for Dry & Wet Bulb / Capacitor type for Humidity.
|
| Internal
Chamber |
Stainless
Steel 304 / 316L quality.
|
| External |
Stainless Steel
Matt Finish / Mild
Steel Powder Coated
|
|
Insulation
|
Body |
Puf 50mm
/ Glass Wool 65mm
|
| Door |
Thermo
Cole.
|
| Inner
Glass Door |
Inner Full
Size Sea through Acrylic 8 mm thick.
|
| Forced
Air Draft |
7"
Tangent Flow by Aluminium blower
|
| Air
Circulation Motor |
1/12
Hp, 1440 R.P.M.
|
| Steam
Injection System |
I.S.I.
Mark Kettle Heater / ultrasonic humidifier.
|
|
Water
tank Cartridge
|
Reservoir |
4
ltrs |
4
ltrs |
9
ltrs |
9
ltrs |
| Boiler |
4
ltrs |
4
ltrs |
9
ltrs |
9
ltrs |
| Water
quality |
pH6.2
to 7.2
|
| Safety
Device |
Water Level
alarm, over heating or humidity soft alarm.
|
|
Optional
|
| Imported
Sensor |
0
to 100% R.H., Accuracy of +/-2% |
| Data
Acquisition |
21
CFR part 11 compliance. |
| Computer
Interface |
RS
485 / RS 232 interface for multiple / single communication
port. |
| Safety device |
Thermostat or
Energy Regulator |
| Cyclic
Timer |
0
to 24 hrs X 7 days cyclic ON / OFF timer for illuminating
condition. |
| Capacity
(watts) |
2000 |
2750 |
3250 |
3750 |
| Power
Consumption |
9
amps |
12
amps |
14
amps |
17
amps |
| Electric
requirements AC230 V & 50 Hz cycle. |
|
